RE: [Flash Operator Panel] SIP trunk shows outgoing status but not incom

["canuck15" <canuck15@xxxxxxxxxxx>]

Thanks so much for the quick replies Nicolas.

So are you suggesting I change the trunk name from [604XXXXXXX] to
[xxx.xxx.xxx.xxx] or to [SIP/xxx.xxx.xxx.xxx]? 

-----Original Message-----
From: Nicolás Gudiño [mailto:nicolas@xxxxxxxxxxxx] 
Sent: Monday, May 14, 2007 10:43 AM
To: operator_panel@xxxxxxxxxxxxxxxxxx
Subject: Re: [Flash Operator Panel] SIP trunk shows outgoing status but not
incoming


> Thanks Nicolas,
>
> I tried changing the trunk name to [604XXXXXXX] but it didn't make a 
> difference.  With an incoming call present I did a 'show channels' and 
> it gave me:
>
> SIP/600-0984fe68     (None)               Up      Bridged
> Call(SIP/xxx.xxx.xxx.xxx-
> SIP/xxx.xxx.xxx.xxx-099 s@xxxxxxxxxx:10      Up      Dial(SIP/600|30|tr)
> 2 active channels
> 1 active call
>
> Where the xxx #'s are the IP of my SIP provider.  Any other suggestions?
>   
Your inbound call is not matching the sip peer definition, you should try
hard to do it by modifying the sip.conf section. FOP matches on channel
name, if the channel name is SIP/xxx.xxx.xxx.xx then the button should be
[SIP/xxx.xxx.xxx]  and not [SIP/providername].

Sometimes is dificult to match both inbound&outbound calls to the same peer
definition, but it is possible. You will have to try. It  is not a FOP issue
but an asterisk config issue.

Best regards,




Flash Operator Panel Mailing List

To unsubscribe send an empty message to:
   <operator_panel-unsubscribe@xxxxxxxxxxxxxxxxxx>
To get help send an empty message to:
   <operator_panel-help@xxxxxxxxxxxxxxxxxx>
The archives can be found at:
   http://www.asternic.org/archives/maillist.html